Self Adjustment – Evolis Badgy 200

  • Use the Sa command to adjust all the sensors in the same process:

Make sure a color ribbon and none card are inside the printer

ln the Maintenance/Printer command prompting, send the Sa command:

When the “warning LED” is flashing open the cover. Close it when it’s flashing again

When the “card/ribbon LED”  is flashing, insert a card in the feeder

The card is fed, ejected. If the answer is Ok, the sensors are adjusted

If this procedure has been followed too slowly, a “timeout” message may be displayed

This entry was posted in Badgy, How-To and tagged , , , , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *