Monthly Archives: January 2013
A little break from fixing printers!
Evolis Primacy and Zenius – Ethernet Setup
Follow the link below to download the Network Administrator Manual for the Evolis Primacy and Zenius. Network_administrator_manual
Update Firmware – Nisca PR53xx Printers
Take the following steps to flash or upgrade the firmware for your Nisca PR5310 or PR5350 printer: Go to Nisca’s website Note: you will need to register or login as a visitor to download the firmware. Download the latest … Continue reading
Cleaning Cycle – Magicard Enduro
Upgrade Firmware – Magicard Enduro
Take the following steps to flash or upgrade your Magicard Enduro firmware: Go to Magicard’s website and download the latest firmware to your desktop Ensure that the printer is on, does not have any errors or print jobs going to … Continue reading
Magnetic Test – DTC1000
Take the following steps if you are experiencing mag encoding errors with your DTC1000: Ensure that the cards are loaded in the correct orientation Try different cards Clean the roller manually as the card may be slipping during the encoding process … Continue reading
Fargo HDP5000 Cleaning Cycle
Take the following steps to run a cleaning cycle on your Fargo HDP5000: Go to your printers and faxes folder. Right click on the Fargo HDP5000 and click printing preferences. Click on the ToolBox button. Click on the clean printer tab … Continue reading
Test Print – Nisca PR5310 & PR 5350
Printing straight from the printer’s screen can tell you if possible problems you’re having are computer/software/driver related, or are actually problems with the printer. Here’s how to print on a Nisca PR53xx printer without using a computer: Go into “Service … Continue reading
Self Adjustment – Evolis Zenius
Use the Sa command to adjust all the sensors in the same process: Make sure a color ribbon and cards are inside the printer. ln the Print center/Maintenance/Printer command prompting, send the Sa command: The “warning-LED” from the control panel … Continue reading
Self Adjustment – Evolis Primacy
Use the Sa command to adjust all the sensors in the same process: Make sure a color ribbon is inside the printer, but remove the stack of cards. In the Print center/Maintenance/Printer command prompting, send the Sa command (this is … Continue reading