If your Fargo HDP600-LC printer is having a “Check Lam” error please take the following steps.
1. Try a different roll of Laminate first
2. Ensure that the laminate is properly installed and not misaligned
3. Calibrate your lamination sensor through the printer driver.
4. Increase the Manual Sensor Calibration by 5-10 points through the printer’s front panel LCD. (Note: If you increase this value and then calibrate the sensor through the driver it will default back to the lower setting)
Press Menu
Scroll down and select Setup Printer
Scroll down to Lam Settings and press select
Scroll down to Sensor Manual and press select
Increase the setting between 5-10 positive points using the up arrow.
Choose save
Run a self test with lamination to ensure the problem is resolved.