Lamination hanging off the edge of the card?

Fargo DTC525-LC, DTC550-LC, HDP600-LC, and HDP5000 Printers

If the lamination patch is hanging off the edge of the card as pictured below, check your lamination type setting in the driver as it is most likely set to film when there is 0.6 or 1.0 PolyGuard installed in the laminator.

Steps to Resolve

1. Go to your printers and faxes folder, right click on your Fargo printer, choose printing preferences.

2. Click on the lamination tab and change the lam type to match the type of laminate that is loaded in the laminator. Click Apply.

3. Run a self test with lamination to from the Fargo Workbench Utility verify that the problem is resolved.

This entry was posted in BadgePros, DTC550, HDP5000, HID Fargo, How-To and tagged , , , , , , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

code