Tag Archives: Elypso
Take the following steps to update your Elypso firmware: Download the latest firmware from Evolis’ website Make sure that there are no print jobs in the print que Open the Evolis Print Center Double Click on the Elypso Printer Click … Continue reading
Take the following steps to manually clean the Evolis Elypso platen roller: Remove the ribbon Press the power button while holding a cleaning card on the printer’s platen roller as shown below
Use the Sa command to adjust all the sensors in the same process: Make sure a color ribbon and cards are inside the printer. ln the Print center/Maintenance/Printer command prompting, send the Sa command: The “warning-LED” from the control panel … Continue reading
Take the following steps to change the Sleep Mode: Open the Evolis Print Center Double Click on the Elypso Printer Click on Administration Change the sleep timer to your preferred time. Click Apply. Click Ok.
You must set the Print Head Kit # in the Elypso Driver and run a cleaning cycle after a print head is replaced: Open the Evolis Print Center Double Click on the Elypso Printer Click on Maintenance and then Print … Continue reading
Please note that the print head is a delicate part of your printer. To avoid any damage to it: Disconnect the printer before cleaning the print head. Fully comply with the recommended cleaning cycles. Always avoid the print head to … Continue reading
To carry out an in-depth clean of your printer, we recommend you clean the card feed rollers in addition to carrying out a basic clean every 5 regular cleans. Open the printer cover. Remove the ribbon from the printer if … Continue reading